Disclaimer: This project was created by Christian Brobst and Christopher Ellis, so both of their blogs will be the same.
Arduino Runner adapt the concept of the mobile game Cube Runner to an Arduino and Unity. Instead of using a mobile phone to control the game, you use a separately connected Arduino. The Arduino is fashioned into a steering wheel for controlling the cube. Try to avoid the obstacles and make it as far as you can!
Arduino Runner uses an Arduino, FLORA accelerometer, single-press button, cardboard, and Unity. The setup and controller can be seen below.
Arduino Runner adapt the concept of the mobile game Cube Runner to an Arduino and Unity. Instead of using a mobile phone to control the game, you use a separately connected Arduino. The Arduino is fashioned into a steering wheel for controlling the cube. Try to avoid the obstacles and make it as far as you can!
Arduino Runner uses an Arduino, FLORA accelerometer, single-press button, cardboard, and Unity. The setup and controller can be seen below.
After you've started the game, it begins immediately so be ready! Tilt the controller left and right to steer the cube left and right and avoid obstacles. If you hit an obstacle you spin out of control and lose. To reset the game at any moment, hit the button on the back of the controller. Once you have finished playing, just exit out of the game by clicking the x in the top right corner.
No comments:
Post a Comment